PROPOSED SERVICE 08
Excavation and Trenching
Clean, accurate excavation saves concrete overruns and protects underground infrastructure. We carry out bulk cuts, detailed footing beams and civil utility trenching with disciplined level control and strict underground service awareness.

WHY THIS SCOPE MATTERS
Site challenge & practical use case
Over-excavated footing trenches waste significant concrete volume, while careless digging near live utilities or neighbouring footings creates major safety and structural hazards. Controlled machine operation paired with service locating keeps trenches crisp and safe.
SCOPE DEFINITION
What is included—and clear service boundaries
Defining scope boundaries upfront prevents assumptions between civil, engineering and building trades.
- Before You Dig Australia (BYDA) plan review and electronic/non-destructive locating coordination
- Detailed excavation for raft edge beams, internal ribs, pad footings and lift pits
- Graded utility and stormwater trenching with specified bedding zones
- Rock sawing and hydraulic rock hammering where hard strata are encountered
- Safe trench battering, benching or shoring coordination for deeper excavations
- Clean spoil loading, separation of reusable fill and site tidy-up
- Contaminated soil classification (waste classification testing) and EPA-regulated hazardous disposal are billed transparently against laboratory reports when required
- Live utility relocations or shutdowns are performed by accredited network authorities
Final inclusions, exclusions, engineering hold points and licensing confirmations are documented in writing within each project quotation.
DELIVERY WORKFLOW
How excavation and trenching progresses
Each stage completes verification checks before moving to the next phase.
- 01
Utility Search & Set-Out
Review BYDA plans, locate existing services on site and mark trench alignments and depths.
- 02
Controlled Excavation
Excavate with appropriately sized buckets and laser depth checks to avoid over-break.
- 03
Trench Safety & Base Clean
Apply benching/shoring controls where depth requires, and clear loose crumb from footing bases.
- 04
Bedding, Backfill or Pour Readiness
Hand over clean trenches for steel fixing or place compacted pipe bedding and warning tape.
FREQUENTLY ASKED QUESTIONS
Questions about excavation and trenching
Have a project-specific question not covered here? Visit our general FAQs page or send us your drawings directly.
We pause and document the depth and extent immediately, notify the client and engineer, and confirm whether rock breaking, dewatering or revised footing depths apply before proceeding.
Excavating below the angle of repose next to existing footings can cause subsidence. Deep boundary or adjacent trenches must follow structural engineering shoring, hit-and-miss staging or piering instructions.
Always. Reviewing current Before You Dig plans and potholing/locating known services before mechanical excavation is a non-negotiable pre-start step.
RELATED PACKAGES
Complementary site & concrete services
Site Preparation and Earthworks
Vegetation clearing, topsoil stripping, cut-and-fill benching and engineered building pads prepared to level tolerances.
Drainage and Stormwater Works
Subsoil agricultural drains, stormwater pits, detention systems and surface overland flow management around structures.
Civil Construction Works
Integrated site infrastructure, bulk groundworks, service corridors and civil packages coordinated to engineering drawings.
Planning detailed footing or utility excavation?
Send through your site suburb, engineering plans or project summary and we will review the scope with you.
